Reference Number: 136773

NEW SHARP VERTICAL MILL 
  MODEL:  LMV-42
 
 TABLE:
 Working Surface...................... 9 x 42"
 T-Slot Number, Size.................. 3, 5/8"
 
 CAPACITY:
 Table Travel: X-Axis................. 30"
 Saddle Travel: Y-Axi................. 12"
 Ram Travel........................... 12"
 Quill Travel: Z-Axi.................. 5"
 Knee Travel.......................... 16"
 Spindle to Column (min-max).......... 6-3/4 - 18-1/2"
 Spindle to Nose to Table............. 2-1/8 - 18"
 
 SPINDLE:
 Motor................................ 3 hp
 Wiring Voltage....................... 220/440V, 3Ph, 60Hz
 Taper................................ R-8
 Speed (vari speed)................... 60-4,500 RPM
 Quill Feed (IPR)..................... 0.0015, 0.003, 0.006"
 Head Swivel.......................... 360 degree
 Head Tilt; right-to-left (each way).. 45 degree
 Head Tilt; up-and-down (each way).... 45 degree
 
 DIMENSIONS & WEIGHT:
 Floor Area (w x d)................... 7 x 6.5"
 Net Weight (approximately)........... 2,400 lbs.
 
 STANDARD EQUIPMENT:
 3 HP Variable Speed head w/Dual Cooling Fans
 ABEC-7 Super-Precision Spindle Bearings
 Self-Lubricating Motor Shaft - extends pulley life
 Cutler-Hammer on/off switch
 Hard-chromed ways 
 Meehanite Casting
 Front and rear rubber way covers 
 Tool kit
 
 OPTIONAL ACCESSORIES (call for pricing):
 DVS (Digital Variable Speed) Head instead of manual variable speed
 Power feeds for table, saddle and/or knee with safety handles
 R-8 collet set
 Kurt or Imported Milling vises
 Clamping kit
 Right-angle milling attachment
 Riser block
 D.R.O. system (Acu-Rite, Newall & Sony can be factory installed)
 Kurt or Imported Power drawbars
 Halogen Worklight